3.3.4. Oil spray nozzle z Assemble the oil spray nozzle. z Tighten the fixing bolts. EFM2059I 3.3.5. Tappet z Coat the tappet wholly with clean oil and push in the tappet hole of the cylinder block. EAMD072S 3.3.6. Crankshaft z Put the wear ring into the heater to heat it up to 150 ~ 200 ° C level, push it over the crankshaft by means of a jig. Wear ring EA6M2009 z Assemble the main bearing to the cylinder block and coat it with engine oil. Then assemble the bearing that has a hole to the cylinder block side and one that has no hole to the bearing cap and be careful not to change. EFM2060I Engine Reassembly - 82 -