Tail light To replace the taillight/brake light bulb, use the following procedure: q NOTE There should be an average opera- ting load on the ATV when adjusting the headlight aim. aim. Proper aim is when the most intense beam is centred on the ver- tical mark 5 cm below the horizontal marks on the aiming surface. 7. Adjust each headlight until cor- rect aim is obtained. 8. Horizontal: Loosen the nut be- side the sealing of the headlight retainer. Adjust proper aiming and tighten the nut securely. 1. Remove the two screws and re- move the cover. 2. Grasp the bulb and turn it coun- ter clockwise. 3. Install the new bulb by turning it clockwise while pushing in. 4. Install the cover. 2.
Measure the distance from the fl oor to the mid-point of each head- light. 3. Using the measurements ob- tained in step 2, make horizontal marks on the aiming surface. 4. Make vertical marks which in- tersect the horizontal marks on the aiming surface. 5. Switch on the lights. MAKE SURE THE HIGH BEAM IS ON. 6. Observe each headlight beam Fuses At the models 400/500/650/700 the fuse box is to be found under the seat. Adjusting Headlight Aim The headlights can be adjusted horizontally (high beam/low beam). The geometric centre of the HIGH beam light zone is to be used for vertical and horizontal aiming. 1.
Position the ATV on a level fl oor so the headlights are approxima- tely 6,1 m from an aiming surface (e.g. a wall). Page 47