Komatsu — CONTROL LEVERS, PEDALS

. OPERATION EXPLANATION OF COMPONENTS PARKING BRAKE LEVER WARNING position. This lever (5) is used to apply the parking brake. WORK EQUIPMENT LOCK LEVER WARNING 3 - 61 When parking the machin e, always set the parking bra ke lever to the L OCK REMARK Before moving the parking brake lever to the LOCK position, return the steering position. , directional, and gearshift lever to the N When starting the e ngine, if the parking brake lever is not in the LOCK position, the limit switch is actuated a nd it is i mpossible to start the engine.

When standing up fr equipment lock lever If the blade control a om the operator's seat, alw securely to the LOCK positio nd ripper control levers are ays move the work n. not locked and are touched by accident, i If the work equipment t may lead to serious injury lock lever is not completely i or damag n the LOC e. K position, the lock may not be a pplied. position shown in the diagram. chine or when performing maintenance, always Check that it is in the position shown in the diagra When parking the ma chine or when performing m ways lower the blade or rip per to the ground, then set the work equipment lock lever to the LOCK position.

Lever (6) is a device t o lock the blade control an d ripper cont rol levers. When it is set to the L OCK position, the TILT, R AISE, L OWE R, an d FLOAT operations a REMARK ine, to ensure safety, always place the work equipment lock lever at the LOCK position. When starting the eng ine, to ensure safety, alw ays plac e the work equipment lock lever at the LOCK position If the work equipment l ock lever is not at the LOC K position, th e limit switch is actuated an d the engine will not s tart.