. OPERATION OPERATION RIPPER OPERATION point. 3 - 151 EFFECTIVE METHOD OF The mo st suitabl e digging a ngle for the shank is w hen the shank is perpe ndicular to the grou nd surface (angle at ti p: 45° - 50 °). For co mparative ly soft ro ck (seism ic velocity: 1200m/s or below), it is also p ossible to carry out ri pping with th e shank tilted to the re ar (maximum rippin On com parativel y hard bed rock, if ripping is carrie d out with the shank ti lted back , there will be excessive wear of the tip of the point ( A), and this will ability.
reduce the effectiveness of the the self-sharpening During r ipping op erations, if the track starts to slip when ripping boulder s or rock that is diffi cult to rip, use the tilt c ylinder. Selectin extreme ly important to obta in effective A variet y of rippe r points to match eac h type of roc k is available, so use "PROCEDURE FOR SELECTING RIPPER )" to selec t the most s uitable ripper DIGGING UP BOULDERS OR ROCKBED lt to rip, if the When ripp ing boulders and ro or the travel spee ckbed tha t are difficu the track slips ravel spee d become s slower, operate the tilt tilt cylinder to lift up th e boulder o r rockbed.