. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER 3 - 162 When adjusting, it is d angerous if the work equipme nt is moved by mistake. Set the work equipmen t in a safe condition, th en stop the engine and lock th e work equipment securely w ith the work e quipment loc NOTICE The maximum tilt is 9 Adjust the tilt so that it does not exceed the limit of 935 mm (3 ft If the maximum tilt is exceeded, excessive force wi ll be brought t o bear on all p arts, and this will When the blade co ntrol lever is operated, the following tilt obtained. Right tilt: 460 mm ( Left tilt:
460 mm (1 If it is necessary to have a greater tilt, do as f ollows Use bar handle (2) fixed to the right brace to turn change the length ( l ) of the brace to give a maximum tilt of 1000 mm (3 ft 3 in). tance between the joints ( l ) is as follows. 372 mm 2 mm The standard dis tance between the joints ( l ) is as follo Semi U-dozer: 1 Sigmadozer: 129 ADJUSTING SHIM IN BLADE CYLINDER CAP Set the standard sh im adjustment in the blade cylinder cap t o 4 mm (0.16 in). alance the wear of the cap and the ball at the d. Remove shims to b alance the wear of the ca p and the ba end of the piston ro The proper clearan ce to be maintained with th e shims is 0. 2 to 0.5 mm (0.008 to 0.02 i n).