Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION METHOD OF ANGLING BLADE WARNING 3 - 164 Angledozers only Whe n adjusting the amo unt of angling, it is da ngerous if the work equipment is moved by mistake . Set the work equipment in a saf e condition , then st op the engine and loc k the work equipment securely with the work equip Be c areful when removin g arm (2) . Afte r arm ( 2) is r emoved, the blade can When dozin g toward on e side only, o perat e with angled blade. 1. above ground, then put blocks u nder the fra me so tha t the blad e doe s not come down. 2. Remove pins (1) on the left a nd r ight si des, then remove arm (2) from the f 3.

Insert ar m (2) into th e desired position o n the bracket on top of the fram e (3 places on each side ), and inser t pin s (1