Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUSTING RIPPER (Unit: mm (in)) 3 - 168 ADJUSTING DIGGING DEP TH There are mounting holes in the shank to chose to matc h the r ipping depth. Normally, use the bottom hole particularl y deep ripping i s needed, use th When cha nging the diggin g depth, do as f 1. Place hamm 2. Remo 3. Insert The han Wh For (PA 1. Place a pointed obje ct on the tip of er to remove fro m the opposite 2. Remo ve pin (2) and c hange the positi on of the shan k hole. 3. Insert pin (1) partially by hand then kn ock it in with a hammer.

pin is one unit , so when inserti artially by d, then knock it in with a hamme en a giant rippe r is installed, use the pin puller details, see "M PULLER GE 3-153)". REPLACING POINT AND PROTECTOR To protect the shank, replace the point an d protector installed to To protec t the shank, rep the tip of t he shank when they are worn. Put a pin r emoval bar in c ontact with the pi n marked by t he arrow, then hit it with a hammer and remove it fro m the opposit e side. NO. Item Judgment s Basic W dimension tandard Action ear limit (1) W ear of point (a) 335 (13.2) 2 25 (8.9) Replace