Komatsu — TIPS FOR LONGER UNDERCARRIAGE LIFE

. OPERATION OPERATION 3 - 171 TIPS FOR LONGER UNDERCARRIA Undercarriage lif e greatly varies depending on operation method , inspection and mainte operation, keep t he following points in mind OPERATION M ETHOD k shoe that best suits the type of soil to be encountered in service. omatsu distributor when selecting track shoes. hoe slipping to occur during operation. g occurs, reduce load on the blade until slipping stops. starts, acceleration or stops, unnecessary high speeds and sharp turns. e machine in a straight line whenever possible.

When making turns, be careful not to allow the Select the trac k shoe that best suits the t ype of soil to be Consult your K omatsu distributor when s Do not allow s hoe slipping to occur durin If shoe slippin g occurs, reduce load on th e blade until slipping Avoid sudden starts, acceleration or stop s, unnecessary high s peeds and sharp turns Always operat e machine i n a straight lin e whenever possible. When making turns, b machine to st ay to one side, so operatio the largest possib Prior to operat ion, clear boulders and ob stacles to prevent machine from riding over t hem while operating. On a slope, op erate the machine parallel to the inclination of the slope.

Do not operate across the slope. A lso when stopping the machine on a slope. When ground slope, the machine should face the top of the inclines to the left or right during digging not continue to dig with the incline. Move the to level ground and start to dig again. cross obstacles that are difficult to move during of the igging operations, do the incline. Move the o dig again. ifficult to move during the machine back to level ground and start t If you come a cross obstacles that are d during dozing operations or ripper operations, and the idler or sprocket come up from the ground, it means that the operation is excessive for the machine, so avoid such operations.

dozing operati ons or ripper operations, an d the idler or sprocket come up fro m the ground, it means that the operatio excessive for the machine , so avoid such