. OPERATION TROUBLESHOOTING CONNECTING THE BOOSTER CABLES STARTING THE ENGINE WARNING 3 - 192 Keep the startin g switch of the normal machine a nd problem machine in th e OFF po sition. Connect the boo ster cable as follows, in the orde r of the numbers marked in the dia 1. Connect the clip of booster cable (A) to the po sitive (+) terminal of battery (C ) on the probl em machine. cable (A) to the 2. Connect the clip at the ot her end of booster positive (+) t erminal of bat tery (D) on the nor mal machine. 3. Connect the clip of booster cable (B) to the ne gative (-) terminal of battery (D ) on the norm al machine. 4.
Connect the clip at the oth er end of booster ca ble (B) to engine block (E) on the problem Always check that the work equip ment lock lever and P arking brake lever i s set to t he LOCK p osition, regardless o f whether the machine is workin g normally or h as failed. Check also that all the control levers ar e in the HO LD or N EUTRAL position. 1. Make sure t he clips are fir mly connected to t he battery terminals. 2. Start the en gine of the boo ster machine and keep it running at high idli ng speed 3. Turn the sta rting switch of problem machine to the START position, and start the engine. If the engine doesn't d start th e engin e.
If t he engine doesn't start at first, try it again aft er 2 minutes. DISCONNECTING THE BOOSTER CABLES After the engine has started, di sconnect the boost er cables in the reverse of the order in whic h the y were connected. 1. Remove the clip of booster cable (B) from engine block (E) on the problem machine. 2. Remove the clip of booster cable (B) from the negative (-) terminal of battery (D) on the normal machine. 3. Remove the clip of booster cable (A) from the positive (+) terminal of battery (D) on the normal machine. 4. Remove the clip of booster cable (A) from the positive (+) terminal of battery (C) on the problem machine. 1.
Remove the clip of booste r cable (B) from en gine block (E) on the problem machine. 2. Remove the clip of boos terminal of b attery (D) on t he normal machin 3. Remove the clip of boos ter cable (A) from terminal of b attery (D) on t he normal machin 4. Remove the clip of boos ter cable (A) from terminal of b attery (C) on t he problem machi