. MAINTENANCE GUIDES TO MAINTENANCE 4 - 3 DUSTY WORKSITES: as follows: ly to see if the air cleaner is dirty or clogged. to avoid clogging. quently. cially the starting motor and alternator, to avoid accumulation of dust. When working at dusty worksites, do Inspect the dust indicator frequent ly to see if the air cleaner is dirty or clogged Clean the radiator core frequently Clean and replace the fuel filter fre Clean electrical components, espe cially the starting motor and alternator, to a void a ccumulation of dust When inspecting or changing the o il, move the machine to a place that is free o f dus t to prevent dirt from getting into the oil. AVOID MIXING OILS:
If a different brand or grade of oil has t o be added, drain the old oil and replace all t he oil with the new brand o r grade of oil. Never mix different brand or gr ade of oil. LOCKING INSPECTION COVERS: position with the lock bar. If inspection or maintenance is performed with Lock inspection cover securely into with inspection cover not locked in positio n, there is a danger that it may be suddenly blow shu t by the win d an d cause injury to the worker. BLEEDING AIR: When hydraulic equipment has been repaired or replaced, or the hydraulic piping has bee n removed and i nstalled again, the air must be bled from t he circuit. For details, see "PROCEDURE FOR BLEEDING AIR FROM ".
AIR HYDRAULIC CIRCUIT (PAGE 4-47) PRECAUTIONS WHEN INSTALLING H YDRAULIC HOSES: where there are O-rings or gasket seals, clean the mounting surface, and forget to assemble the O-rings and gaskets. When removing parts at locations replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gaskets When installing the hoses, do not twist them or bend them sharply. If they are installed so, their service life will be shortened extremely and they may be damaged. clean the CHECKS AFTER INSPECTION AND M AINTENANCE:
If y ou forget to perform the checks afte r inspection and maintenance, unexpected p roblems may occur, and t his may lead to serious injury or property dam age. Always do the following: e stopped) enance points been forgotten? nance items been performed correctly? Checks after operation (with engin Have any inspection and maint Have all inspection and mainte Have any tools or parts been d inside the machine and get cau Are there any leakage of coola Have any inspection and maint Have all inspection and mainte Have any tools or parts been d ropped inside the machine? It is particularl y dangerous i f parts are d ropped ght in the lever linkage mechanism. nt or oil?
Have all nuts and bolts been tightened? Are there any leakage of coola nt or oil? Have all nuts and bolts been tightened? Checks when engine is running For the checks when the engine RUNNING (PAGE 2-31)" in the Check that the inspected and m Raise the engine speed and ch For the checks when the engine is running, see "TWO WORKERS FOR MAINTENANCE WHEN ENGIN E IS SAFETY section, and take care of safety s ufficiently Check that the inspected and m Raise the engine speed and ch