. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 9. After replacing the element, push the dust indicator button to reset it. The yellow piston will return to its original position. 4 - 27 NOTICE When inserting the element, if the r ubber at the tip is swollen or the outer element is not pushed in straight, a nd cover (3) is assembled by force to hook (2), there is danger that the hook and air cleaner body may be mbling. damaged, so be careful when asse 8. Install cover (3) as follows. element. ) to the protruding part of the air in position.
1) Align cover (3) with the 2) Hook the tip of hook (2 cleaner body and lock it 3) When locking hooks (2) on opposite sides (top, as when tightening bolts 4) When cover (3) is ins between the air cleaner If it is too large, install a in position, apply the hooks in turn bottom, left, right) in the same way . talled, check that the clearance body and cover (3) is not too large. gain. CHECK AND ADJUST TRACK TE NSION The wear of pins and bushings o n the undercarriage will vary with th e working conditions and types of soil. It is thus necessary to continually inspec t the track tension so as to maintain the standard tension.
Carry out the check and adjust ment under the same conditions as becomes clogged with mud, me asure with the track clogged with mud) INSPECTION Stop the machine on level grou nd (stop with the transmission in FORWARD without applying th e brake). Then place a straight bar o n the track shoes between the carrier roller and the idler as shown in the figure, and measure the c grouser at the midpoint. If the c learance between the bar and the learance (A) is 20 to 30 mm (0.79 rd. e standard value, adjust it in the to 1.18 in), the tension is standa If