Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE ADJUST IDLER CLEARANCE ADJUSTMENT REMARK 4 - 31 The idler moves to the front and rear under external force . When this happens, guide plate (2) b ecomes worn. It guide p late (2) becomes worn, the idler will slip to the side or tilt at an angle. This will l ead t o the track shoe slippin g or cause uneven wear, s o adjust as f ollow 1. Trave l on flat ground for 1 to 2 m (39.4 to 78.8 in), then remove cover (3) (both in and out of ) on the side face of the id ler. 2. Measure clearance A (4 p outside) between the track frame an 3.

If clearance A is more than 3 mm (0.118 in), loosen bolt (1), and remove the shim to adjust t he clearance to a maximu m of 0.5 to 1 m m (0.020 to 0.039 in) The thickness of 1 shim is 1.0 m