. MAINTENANCE SERVICE PROCEDURE CLEAN AND CHECK RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS CLEANING BY ROTATING COOLING FAN IN REVERSE DIRECTION direction, first run the engine at low idling, then stop it. The dust and dirt stuck to the radiator and cooler can be blown out "FAN REVERSE MODE (PAGE 3-51)". 4 - 35 Carry out this procedure if there is a ny mud or dirt stuck to the radiator REMARK Check the hydraulic cooler hoses. If any hose is cracked or hardened by age, replace with a new hose. Also check and tighte n all loose hose clamps. NOTICE When rotati ng the cooling fan in the reve rse direction, be extremely careful of flying du st.
When stop ping the engine when the coo ling fan is rotating in the reverse by rotatin g the cooling fan in the rev 1. Turn s tarting switch (1) to the "O FF" position and stop t he engine 2. Turn s tarting switch (1) to the "O 3. Set th e fan reverse mode on the tails of the method of sett REMARK When the engine is running, even if t he fan rotation selector switch is operate d, the direction of rotation of the fan will not change. The scree nshot on the right is displa yed to inform the operator t hat the directi on of rotation of the fan ha s not changed. steps 2 and 3 above. Stop the e ngine once and follow the 4. Turn s tarting switch (1) to the S directi 5.
Run th Select Norm Exces the time for running the e ngine at high idle as follow s according to the conditio al clogging: 1 to 2 minutes sive clogging: 2 to 3 minu 6. After c ompleting the cleaning, r un the engine at low idl e fo r approx. t th e engine. The cooling fan will rotate in the reverse