. MAINTENANCE SERVICE PROCEDURE Tightening torque for drain plug (P): 68.6 ± 9.81 Nm (7 ± 1 kgm , 50.6 ± 7.2 lbft) Tightening torque for drain valve (2): 63.7 ± 14.7 Nm (6.5 ± 1. 5 kgm , 47 ± 10.8 lbft) 4 - 65 3. 4. 3. Taking care n ot to get o il over yourself, remove drain plug (P) slowly, then loosen drain valve (2) and drai n the oil. Be careful not to loose n the drain valve too much and deform the stopper pin inside the valv 4. Check the dr ained oil, Komatsu distr ibutor. contact your 5. Tighte n drain plug (P) a nd 6. Using t he filte r wrench, turn full-flow filter cartridge (3) To prevent ge tting oil o n yourself, do not carry out thi s operation from immediately under the 7.
Clean t he filter holder, fi ll the new filter cartridge with e ngine oil, coat the packing surface and t hread with e ngine oil (or coat it t hinly with grease), then install the filter c REMAR Check that there i s no old p acking stuck to the filter holder . If there is any old packing stuck to the filter, it will c ause leakag e of