Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE seen at the top. level (25 is low, add 4 - 82 3) Lower c over (2) gradually t o open it. Drain plug ( P) can be Remove dip oil. After drainin 4. Add oil throu gh the holder of d ipstick (G ). After adding the oil, insert dipstic 5. Remove any dirt or dus t stuck to breath er (5), then wash with clean diese l oil or fl ushing oil. If it w part. leaned completely, replace wit h a ne 6. Install under cover (2), t hen clo se engin e side c over (1) on the left side of th e machine CHECK PIVOT BEARING OIL LEVEL, ADD O 1. 2. 3. 1. Remove plu 2. Check that t shown in th e diagram. through the hole of plug 3.

Install plug ( 1.0 in)) engine