TROUBLESHOOTING [115] Error code [115] (Trouble in operation of windshield wiper) 20-318 PC130-7 (1) User code Error code Trouble Trouble in operation of windshield wiper (Monitor panel system) – 115 Contents of trouble • When the wiper operates, the W-signals of both ends of the operating range are not input. Action of monitor panel • Turns the operation signal to the wiper motor OFF. Problem that appears on machine • The windshield wiper does not operate. Related information • The input state (ON/OFF) from the W-signals of the wiper operating range can be checked with the monitoring function. (Code:
049, Center of lower line) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective wiper motor (Internal disconnection) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. W04 (male) Wiper blade Resistance Between (6) and (5) Top of operating range Max. 1 z Other than top of operating range Min. 1 Mz 2 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch.
Wiring harness between P01 (female) (5) and W04 (female) (6) Resistance Max. 1 z Wiring harness between W04 (female) (5) and chassis ground (A11, A12) Resistance Max. 1 z 3 Defective monitor panel aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting. P01 Wiper blade Voltage Between (5) and chassis ground Top of operating range Max. 1 V Other than top of operating range 20 – 30 V