Komatsu — TROUBLESHOOTING

TROUBLESHOOTING [213] Error code [213] (Disconnection in swing holding brake solenoid) 20-328 PC130-7 (1) User code Error code Trouble Disconnection in swing holding brake solenoid (Governor and pump controller system) E03 213 Contents of trouble • When the signal is output to the swing holding brake solenoid circuit, no current flows. Action of controller • None in particular (Since no current flows, the solenoid does not operate). • If the cause of the failure disappears, the system resets itself. Problem that appears on machine • The machine cannot swing (The swing holding brake is not released).

Related information • The operation state (ON/OFF) of the swing holding brake solenoid can be checked with the monitoring function. (Code: 023, Center of upper line) • If the solenoid and wiring harness are normal, the machine can swing by setting the swing holding brake release switch in the FREE position. (The swing holding brake does not operate when the machine stops swinging, however.) • During troubleshooting, keep the swing lock switch in the OFF position and the swing holding brake re- lease switch in the RELEASE position.

• Since the controller detects disconnection while the solenoid output is turned ON, be sure to turn the solenoid output ON when checking for reproduction of the failure after repair. (For the method of turn- ing the solenoid output ON and OFF, see troubleshooting for error code [203].) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective swing holding brake solenoid (Internal disconnection) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch.

V05 (male) Resistance Between (1) and (2) 20 – 60 z 2 Defective swing lock switch (Internal disconnection) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. X05 (female) Swing lock switch Resistance Between (3) and (4) OFF Max. 1 z ON Min. 1 Mz 3 Defective assembled-type diode D01 (Internal discon- nection) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch.

D01 (male) Digital circuit tester Continuity Between (7) and (3) Diode mode There is continuity 4 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between C03 (female) (37) and D01 (female) (7) Resistance Max. 1 z Wiring harness between D01 (female) (3) and J02 and X05 (male) (3) Resistance Max. 1 z Wiring harness between X05 (male) (4) and V05 (female) (1) Resistance Max. 1 z Wiring harness between C03 (female) (3), (13), (23) and V05 (female) (2) Resistance Max.

1 z 5 Short circuit with power source in wiring harness (Contact with 24-V circuit) aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting. Between C03 (female) (37) – D01 (female) (7) wiring harness and chassis ground Voltage Max. 1 V 6 Defective governor and pump controller aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. C03 (female) Disconnect D01 and connect (3) and (7) on female side. Resistance Between (37) and (3), (13), (23) 20 – 60 z