TROUBLESHOOTING E-5 E-5 Auto-decelerator does not operate 20-414 PC130-7 (1) Trouble • Auto-decelerator does not operate. Related information • Since the auto-decelerator is set to 1,400 rpm, it does not operate if the fuel control dial is not set above this level. • Check the display on the monitor panel while the engine is running. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective boom RAISE signal Monitoring code 6-bit display (Center of lower line) When lever is operated: ON 020 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-23.
2 Defective boom LOWER signal Monitoring code 6-bit display (Center of upper line) When lever is operated: ON 020 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-24. 3 Defective arm IN signal Monitoring code 6-bit display (Left of upper line) When lever is operated: ON 020 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-25. 4 Defective arm OUT signal Monitoring code 6-bit display (Left of lower line) When lever is operated: ON 020 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-26.
5 Defective bucket CURL signal Monitoring code 6-bit display (Right of upper line) When lever is operated: ON 021 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-27. 6 Defective bucket DUMP signal Monitoring code 6-bit display (Right of lower line) When lever is operated: ON 021 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-28. 7 Defective swing signal Monitoring code 6-bit display (Right of upper line) When lever is operated: ON 020 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-29.
8 Defective travel signal Monitoring code 6-bit display (Right of lower line) When lever is operated: ON 020 When lever is in neutral: OFF If the display on the monitor panel is abnormal, carry out troubleshooting for E-30. 9 Defective attachment signal Monitoring code 6-bit display (Center of lower line) When lever is operated: ON 021 When lever is in neutral: OFF IIf the display on the monitor panel is abnormal, carry out troubleshoot- ing for E-31. 10 Defective governor and pump controller Troubleshooting cannot be carried out since the defect is in the gover- nor and pump controller (If none of causes 1 – 9 is the cause of the trou- ble, the governor and pump controller is defective).