TROUBLESHOOTING E-14 Circuit diagram related to air cleaner clogging switch PC130-7 20-427 (1) Trouble (3) Air cleaner clogging monitor flashes. Related information • While the engine is running, if the air cleaner clogging monitor detects clogging of the air cleaner, it flashes. • The input state (ON/OFF) from the air cleaner clogging switch can be checked with the monitoring func- tion. (Code:
046, Right of upper line) Possible cause and standard value in norma state Cause Clogging of air cleaner 1 (When system is normal) Defective air cleaner 2 clogging switch (Internal disconnection) s Disconnection in wiring l harness 3 (Disconnection in wiring harness or defective contact in connector) 4 Defective monitor panel Standard value in normal state/Remarks on troubleshooting Check the air cleaner. If it is clogged, clean or replace it. aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. A31 (male) Air cleaner Resistance Between (1) and (2) When normal Max. 1 z When clogged Min.
1 Mz a Prepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between P02 (female) (5) and R A31 (female) (1) esistance Max. 1 z Wiring harness between P11 (female) (2) and R chassis ground (A15) esistance Max. 1 z aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. P02 Air cleaner Voltage Between (5) and chassis ground When normal Max. 1 V When clogged 20 – 30 V