Komatsu — TROUBLESHOOTING

TROUBLESHOOTING E-18 E-18 Swing lock monitor is abnormal 20-432 PC130-7 (1) Trouble (1) When swing lock switch is set in LOCK position, swing lock monitor does not light up. (2) When swing lock switch is set in OFF position, swing lock monitor does not go off. Related information • If the swing holding brake release switch is set in the RELEASE position, the swing lock monitor flashes. • The input state (ON/OFF) from the swing lock switch can be checked with the monitoring function. (Code:

022, Left of upper line, 049, Right of upper line) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective swing lock switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. X05 (female) Swing lock switch Resistance Between (1) and (2) OFF Min. 1 Mz LOCK Max. 1 z 2 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch.

Wiring harness between P02 (female) (17) and J02 and X05 (male) (1) Resistance Max. 1 z Wiring harness between X05 (male) (2) and J05 and chassis ground (A13) Resistance Max. 1 z 3 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Between P02 (female) (17) – J02 – X05 (male) (1) or C02 (female) (38) wiring harness and chassis ground Resistance Min. 1 Mz 4 Short circuit with power source in wiring harness (Contact with 24-V circuit) aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting.

Between P02 (female) (17) – J02 – X05 (male) (1) or C02 (female) (38) wiring harness and chassis ground Voltage Max. 1 V 5 Defective monitor panel aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. P02 Swing lock switch Voltage Between (17) and chassis ground OFF 20 – 30 V LOCK Max. 1 V