Komatsu — TROUBLESHOOTING

TROUBLESHOOTING E-20 E-20 Windshield wiper and windshield washer do not operate 20-436 PC130-7 (1) Trouble (1) Windshield wiper does not operate. Related information • The input state (ON/OFF) from the window rear limit switch can be checked with the monitoring function. (Code: 049, Center of upper line) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective window rear limit switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. W03 (male) Front window Resistance Between (1) and (2) When installed to front Min.

1 Mz When stored in rear Max. 1 z 2 Defective wiper motor (Internal disconnection) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. W04 (female) Continuity Between (3) and (1) There is continuity 3 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between P01 (female) (9) and W04 (male) (3) Resistance Max. 1 z Wiring harness between P01 (female) (10) and W04 (male) (1) Resistance Max.

1 z 4 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Between P02 (female) (15) – W03 (female) (1) wiring harness and chassis ground Resistance Min. 1 Mz 5 Defective monitor panel (Window rear limit switch system) aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting. P02 Front window Voltage Between (15) and chassis ground When installed to front 20 – 30 V When stored in rear Max.

1 V Defective monitor panel (Wiper motor system) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. P01 Wiper switch Voltage Between (9) and chassis ground Between (10) and chassis ground OFF Max. 1 V ON Max. 1 V 20 – 30 V (Constant period)