Komatsu — TROUBLESHOOTING

TROUBLESHOOTING E-21 E-21 Lower windshield wiper does not operate 20-440 PC130-7 (1) Trouble • Lower windshield wiper does not operate. Related information Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective fuse No. 6 If the fuse is broken, the circuit probably has a grounding fault, etc. (See cause 6.) 2 Defective lower wiper switch (Internal disconnection) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. P06 (female) Lower wiper switch Resistance Between (1) and (2) When OFF Min. 1 Mz When ON Max.

1 z 3 Defective lower wiper motor (Internal disconnection) aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting. M92 (female) Lower wiper switch Resistance Between (1) and chassis ground ON 20 – 30 V Between (2) and chassis ground Max. 1 z Between (3) and chassis ground 20 – 30 V Between (4) and chassis ground Max. 1 V If the voltage and resistance are normal and the lower windshield wiper does not operate, the lower wiper motor is defective. 4 Defective lower wiper relay (Internal disconnection) aReplace relay while starting switch is OFF, then turn starting switch ON and carry out troubleshooting.

When the right lower wiper relay is replaced with another one, if the condition becomes normal, the relay is defective. R18 5 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between FB1-6 outlet and J10 and M92 (female) (3) or R18 (female) (5) or P06 (male) (1) Resistance Max. 1 z Wiring harness between R18 (female) (1) and P06 (male) (2) Resistance Max. 1 z Wiring harness between M92 (female) (2), D03 (female) (5), R18 (female) (2) and J09 and chassis ground (T05) Resistance Max.

1 z Wiring harness between R18 (female) (3) and D03 (female) (1) or M92 (female) (1) Resistance Max. 1 z Wiring harness between R18 (female) (6) and M92 (female) (6) Resistance Max. 1 z 6 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Between FB1-6 outlet – J10 – M92 (female) (3) or R18 (female) (5) or P06 (male) (1) wiring har- ness and chassis ground Resistance Min. 1 Mz Between R18 (female) (1) – P06 (male) (2) wir- ing harness and chassis ground Resistance Min.

1 Mz Between R18 (female) (3) – D03 (female) (1) or M92 (female) (1) wiring harness and chassis ground Resistance Min. 1 Mz Between R18 (female) (6) – M92 (female) (6) wiring harness and chassis ground Resistance Min. 1 Mz