Komatsu — TROUBLESHOOTING

TROUBLESHOOTING E-22 E-22 Caution buzzer does not stop 20-442 PC130-7 (1) Trouble • Caution buzzer does not stop. Related information • The input state (ON/OFF) from the caution buzzer stop switch can be checked with the monitoring func- tion. (Code: 045, Right of upper line) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective caution buzzer stop switch (Internal disconnection) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. P03 (female) Caution buzzer stop switch Resistance Between (1) and (2) Released Min. 1 Mz Pressed Max.

1 z 2 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between P02 (female) (16) and P03 (male) (1) Resistance Max. 1 z Wiring harness between P03 (male) (2) and J05 and chassis ground (A13) Resistance Max. 1 z 3 Short circuit with power source in wiring harness (Contact with 24-V circuit) aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting. Between P02 (female) (16) – P03 (male) (1) wiring harness and chassis ground Voltage Max.

1 V 5 Defective monitor panel aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting. P02 Caution buzzer stop switch Voltage Between (16) and chassis ground Released 20 – 30 V Pressed Max. 1 V