Komatsu — TROUBLESHOOTING

TROUBLESHOOTING E-31 E-31 Monitoring function does not display "service" normally When 1 attachment is installed 20-460 PC130-7 (1) Trouble • Monitoring function does not display "Service" normally. The monitoring function (special function) of the monitor panel does not display "Service" normally. Related information • 6-bit position of service oil pressure switch (Code: 0201, Center of lower line) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective service 1 (front) oil pressure switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting.

S10 (male) Service pedal 1 Resistance Between (1) and (2) Neutral position Min. 1 Mz Front position Max. 1 z 2 Defective service 1 (rear) oil pressure switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. S11 (male) Service pedal 1 Resistance Between (1) and (2) Neutral position Min. 1 Mz Rear position Max. 1 z 3 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between C02 (female) (35) and S10 (female) (1) or S11 (female) (1) Resistance Max.

1 z Wiring harness between S10 (female) (2) and chassis ground (A16) Resistance Max. 1 z Wiring harness between S11 (female) (2) and chassis ground (A16) Resistance Max. 1 z 4 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Between C02 (female) (35) – S10 (female) (1) or S11 (female) (1) wiring harness and chassis ground Resistance Min. 1 Mz 5 Short circuit with power source in wiring harness (Contact with 24-V circuit) aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting.

Between C02 (female) (35) – S10 (female) (1) or S11 (female) (1) wiring harness and chassis ground Voltage Max. 1 V 6 Defective governor and pump controller aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. C02 Service pedal 1 Voltage Between (35) and chassis ground Neutral position 20 – 30 V Front or rear position Max. 1 V