Komatsu — TROUBLESHOOTING

TROUBLESHOOTING E-31 When 2 attachments are installed 20-462 PC130-7 (1) Trouble • Monitoring function does not display "Service" normally. The monitoring function (special function) of the monitor panel does not display "Service" normally. Related information • 6-bit position of service oil pressure switch (Code: 0201, Center of lower line) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective service 1 (front) oil pressure switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting.

S10 (male) Service pedal 1 Resistance Between (1) and (2) Neutral position Min. 1 Mz Front position Max. 1 z 2 Defective service 1 (rear) oil pressure switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. S11 (male) Service pedal 1 Resistance Between (1) and (2) Neutral position Min. 1 Mz Rear position Max. 1 z 3 Defective service 2 (front) oil pressure switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. S21 (male) Service pedal 2 Resistance Between (1) and (2) Neutral position Min. 1 Mz Front position Max.

1 z 4 Defective service 2 (rear) oil pressure switch (Internal disconnection or short circuit) aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. S22 (male) Service pedal 2 Resistance Between (1) and (2) Neutral position Min. 1 Mz Rear position Max. 1 z 5 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between C02 (female) (35) and S10 (female) (1) or S11 (female) (1) or S21 (female) (1) or S22 (female) (1) Resistance Max.

1 z Wiring harness between S10 (female) (2) and chassis ground (A16) Resistance Max. 1 z Wiring harness between S11 (female) (2) and chassis ground (A16) Resistance Max. 1 z Wiring harness between S21 (female) (2) and chassis ground (A16) Resistance Max. 1 z Wiring harness between S22 (female) (2) and chassis ground (A16) Resistance Max. 1 z 6 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Between C02 (female) (35) – S10 (female) (1) or S11 (female) (1) or S21 (female) (1) or S22 (female) (1) wiring harness and chassis ground Resistance Min.

1 Mz 7 Short circuit with power source in wiring harness (Contact with 24-V circuit) aPrepare with starting switch OFF, then turn starting switch ON and car- ry out troubleshooting. Between C02 (female) (35) – S10 (female) (1) or S11 (female) (1) or S21 (female) (1) or S22 (female) (1) wiring harness and chassis ground Voltage Max. 1 V 8 Defective governor and pump controller aPrepare with starting switch OFF, then start engine and carry out trou- bleshooting. C02 Service pedals 1 and 2 Voltage Between (35) and chassis ground Neutral position 20 – 30 V Front or rear position Max. 1 V