Komatsu — TROUBLESHOOTING

TROUBLESHOOTING E-33 E-33 Travel alarm does not sound or does not stop sounding When travel alarm is installed PC130-7 20-475 (1) Trouble (1) Alarm does not sound while machine is traveling. (2) Alarm sounds while machine is stopped. Related information Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective fuse No. 15 If the fuse is broken, the circuit probably has a grounding fault, etc. (See cause 4.) 2 Defective travel signal aStart engine and carry out troubleshooting (Travel lever). Monitoring code 6-bit display (Right of lower line) When lever is operated: ON 020 When lever is in neutral:

OFF 3 Disconnection in wiring harness (Disconnection in wiring harness or defective contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Wiring harness between FB1-15 outlet and J03 and A43 (female) (1) Resistance Max. 1 z Wiring harness between A43 (female) (2) and J01 (male) (19) Resistance Max. 1 z 4 Short circuit with chassis ground in wiring harness (Contact with ground circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch. Between FB1-15 outlet – J03 – A43 (female) (1) or other related circuit wiring harness and chassis ground Resistance Min.

1 Mz 5 Defective travel alarm Troubleshooting cannot be carried out since the defect is in the travel alarm (If none of the above causes 1 – 4 is the cause of the trouble, the travel alarm is defective).