Komatsu — TROUBLESHOOTING

TROUBLESHOOTING S-1 S-1 Starting performance is poor (Starting always takes time) General causes why exhaust smoke comes out but engine takes time to start Defective electrical system Insufficient supply of fuel a 20-606 PC130-7 (1) Insufficient intake of air Improper selection of fuel (At ambient temperature of ASTM D975 No. 2 diesel fu Battery charging rate and gr –10°C or below, el is used) avity 0 % 80 % 75 % 70 % 1.26 1.24 1.23 1.22 1.27 1.25 1.24 1.23 1.28 1.26 1.25 1.24 exceed the value for the charging le. avity must exceed the value for the above table.

Causes Worn piston ring, cylinder Defective contact of valve, valve seat Clogged air cleaner element Clogged fuel filter, strainer Clogged feed pump gauze filter Electrical intake air heater Charging rate Ambient temperature 100 % 9 0 % 80 % 75 % 20°C 1.28 1.26 1.24 1.23 0°C 1.29 1.27 1.25 1.24 –0°C 1.30 1.28 1.26 1.25 The specific gravity should rate of 70% in the above tab In cold areas the specific gr charging rate of 75% in the Check items Questions Confirm recent repair history Degree of use of machine Operated for long period Ease of starting Gradually became worse Starts when warm Indicator lamp does not light up Engine oil must be added more frequently Replacement of filters has not been carried out according to operation Manual Non-specified fuel has being used Dust indicator lamp is red Battery charge lamp is ON Starting motor cranks engine slowly When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low Engine does not pick up smoothly, and combustion is irregular Blow-by gas is excessive Timing lock on fuel injection pump does not match Mud is stuck to fuel tank cap When engine is cranked with starting motor, 1) Little fuel comes out even when injection pump piping sleeve nut is loosened 2) Little fuel comes out even when fuel filter air bleed plug is loosened Leakage from fuel piping There is hunting from engine (rotation is irregular) Troubleshooting When compression pressure is measured, it is found to be low When air cleaner element is inspected directly, it is found to be clogged When fuel filter, strainer are inspected directly, they are found to be clogged When feed pump strainer is inspected directly, it is found to be clogged Heater mount does not become warm Is voltage 26–30V between alternator terminal B and terminal E with engine at low idling?

Yes No Either specific gravity of electrolyte or voltage of battery is low Speed does not change when operation of certain cylinders is stopped When control rack is pushed, it is found to be heavy or does not return (check after removing fuel injection pump) When fuel tank cap is inspected directly, it is found to be clogged Replace Correct Replace Remedy Clean Clean Clean Use a test stand when adjusting. Remedy Replace Correct Clean Clean Clean Replace