Komatsu — TROUBLESHOOTING

TROUBLESHOOTING S-14 S-14 Water temperature becomes too high (Overheating) General causes why water temperature becomes too high 20-622 PC130-7 (1) Lack of cooling air (deformation, damage of fan) Drop in heat dissipation efficiency Defective cooling circulation system Rise in oil temperature in power train a Carry out troubleshooting for chassis.

Causes nekorB retaw pmup ,deggolC dehsurc rotaidar snif Clogged radiator core Defective thermostat (does not open) Defective water temperature gauge Lack of cooling water Fan belt slipping, worn fan pulley Clogged, broken oil cooler evitcefeD erusserp evlav nekorB rednilyc ,daeh daeh teksag seloH edam yb gnittip esiR ni euqrot retrevnoc lio erutarepmet Questions Check items Confirm recent repair history Degree of use of machine Operated for long period Condition of overheating Suddenly overheated Always tends to overheat Water temperature gauge Rises quickly Does not go down from red range Radiator water level sensor lights up Fan belt whines under sudden load Cloudy white oil is floating on cooling water Cooling water flows out from overflow hose Excessive air bubbles inside radiator, water spurts back Engine oil level has risen, oil is cloudy white There is play when fan pulley is rotated Radiator shroud, inside of underguard are clogged with dirt or mud When light bulb is held behind radiator, no light passes through Water is leaking because of cracks in hose or loose clamps When belt tension is inspected, it is found to be loose Power train oil temperature enters red range faster than engine water temperature Troubleshooting Temperature difference between top and bottom radiator tanks is excessive Carry out troubleshooting for chassis.

Temperature difference between top and bottom radiator tanks is slight When water filler port is inspected, core is found to be clogged When function test is carried out on thermostat, it does not open even at cracking temperature When water temperature is measured, it is found to be normal When oil cooler is inspected directly, it is found to be clogged When measurement is made with radiator cap tester, set pressure is found to be low When compression pressure is measured, it is found to be low Remove oil pan and inspect directly Remedy Replace Correct Correct Replace Replace Add Correct Replace Replace Replace Replace —