TESTING AND ADJUSTING TESTING PROCEDURE FOR DIODE TESTING PROCEDURE FOR DIODE a Test an assembled-type diode (18-pin) or a diode (2-pin) according to the following procedure. a The conductive direction of an assembled-type diode is shown in the following figure. 2. When using an analog circuit tester 1) Set the circuit tester in the resistance range. 2) Apply the test pins as shown below and check movement of the pointer. i) Apply the red (+) test pin to the anode (P) side of the diode and the black (-) test pin to the cathode (N) side. ii) Apply the red (+) test pin to the cathode (N) side of the diode and the black (-) test pin to the anode (P) side.
3) Judge the condition of the diode from move- ment of the pointer. The pointer does not move in i) above but moves in ii): Normal (Moving angle (Resistance) depends on the type and measurement range of the circuit tester, however) The pointer moves in both i) and ii): Defective (Internal short circuit) The pointer does not move in either of i) and ii): Defective (Internal disconnection) a The conductive direction of a diode is marked on its surface. 1. When using a digital circuit tester 1) Set the circuit tester in the diode range and check the indicated value. a If an ordinary tester is used, the voltage of the battery in itself is indicated.
2) Apply the red (+) test pin to the anode (P) side of the diode and the black (-) test pin to the cathode (N) side and read the indicated value. 3) Judge the condition of the diode from the indicated value. The indicated value does not change: There is not continuity (Defective). The indicated value changes: There is continuity (Normal) (Note). Note) In the case of a silicon diode, the cir- cuit tester indicates a value of 460 – 600. 20-146 PC130-7 (1)