Komatsu — 20-201--.pdf

TESTING AND ADJUSTING SPECIAL FUNCTIONS OF MONITOR PANEL 5. Function of adjusting governor [03] This function is used to adjust the governor lever stroke after the governor actuator, fuel injection pump, or governor spring is removed and installed or replaced, or when the high idling speed is low or engine speed is not stabilized. 3) Adjusting governor lever stroke a The turning direction of the governor spring described below is the direction when the governor actuator is seen from the fuel injection pump side. i) Keep the fuel control dial in the MAX position. ii) Loosen locknut (2) on the governor actu- ator side of governor spring (1).

iii) Turn governor spring (1) clockwise to reduce its installed length (a) and return governor lever (3) of the fuel injection pump to a position where it does not touch the full stopper. iv) Turn governor spring (1) counterclock- wise to increase its installed length (a) and stop it when governor lever (3) of the fuel injection pump touches the full stop- per. Standard installed length (a) (Refer- ence): 262 mm v) Turn governor spring (1) counterclock- wise further by 2.5 turns to compress the spring in governor spring (1).

a Since the inside spring is com- pressed, only the outer cylinder of governor spring (1) moves toward the fuel injection pump by about 3.1 mm (the installed length does not change). vi) Fixing governor spring (1), tighten lock- nut (2) on the governor actuator side. a Before fixing the locknut, check that the water drain hole of the governor spring is directed down. If the water drain hole is not directed down, loosen locknut (4) on the fuel injec- tion pump side and turn the whole governor spring to adjust (Take care not to change the adjustment dimen- sion of the governor spring). 1) Selecting and executing function i) Select menu No. [03] in the menu selec- tion mode.

ii) Press set switch (5) to execute this func- tion. 2) Condition of governor motor If this function is executed, all the governor control functions are cancelled, and then the operating angle of the governor actuator fol- lows up only the operation signal of the fuel control dial. a While this function is executed, [GOV] is displayed in display section (1) and [gSET] is displayed in service meter sec- tion (2). 3 Locknut: 11.8 – 19.6 Nm {1.2 – 2.0 kgm} 20-160 PC130-7 (1)