Komatsu — 6. Measures to remove root cause of failure

TROUBLESHOOTING POINTS TO REMEMBER WHEN TROUBLESHOOTING POINTS TO REMEMBER WHEN TROUBLESHOOTING k Stop the machine in a level place, and check that the safety pin, blocks, and parking brake are securely fitted. k When carrying out the operation with two or more workers, keep strictly to the agreed signals, and do not allow any unauthorized person to come near. k If the radiator cap is removed when the engine is hot, hot water may spurt out and cause burns, so wait for the engine to cool down before starting troubleshooting. k Be extremely careful not to touch any hot parts or to get caught in any rotating parts.

k When disconnecting wiring, always disconnect the negative (–) terminal of the battery first. k When removing the plug or cap from a location which is under pressure from oil, water, or air, always release the internal pressure first. When installing measuring equipment, be sure to connect it properly. The aim of troubleshooting is to pinpoint the basic cause of the failure, to carry out repairs swiftly, and to prevent reoccurrence of the failure. When carrying out troubleshooting, and important point is of course to understand the structure and func- tion.

However, a short cut to effective troubleshooting is to ask the operator various questions to form some idea of possible causes of the failure that would produce the reported symptoms. 1. When carrying out troubleshooting, do not hurry to disassemble the components. If components are disassembled immediately any failure occurs: Parts that have no connection with the failure or other unnecessary parts will be disassem- bled. It will become impossible to find the cause of the failure. It will also cause a waste of manhours, parts, or oil or grease, and at the same time, will also lose the confidence of the user or operator.

For this reason, when carrying out troubleshoot- ing, it is necessary to carry out thorough prior investigation and to carry out troubleshooting in accordance with the fixed procedure. 5) Other maintenance items can be checked externally, so check any item that is consid- ered to be necessary. 4. Confirming failure Confirm the extent of the failure yourself, and judge whether to handle it as a real failure or as a problem with the method of operation, etc. a When operating the machine to reenact the troubleshooting symptoms, do not carry out any investigation or measure- ment that may make the problem worse. 5.

Troubleshooting Use the results of the investigation and in- spection in Items 2 – 4 to narrow down the causes of failure, then use the troubleshoot- ing flowchart to locate the position of the fail- ure exactly. a The basic procedure for troubleshooting is as follows. 1) Start from the simple points. 2) Start from the most likely points. 3) Investigate other related parts or information. 2. Points to ask user or operator 1) Have any other problems occurred apart from the problem that has been reported? 2) Was there anything strange about the machine before the failure occurred? 3) Did the failure occur suddenly, or were there problems with the machine condition before this?

4) Under what conditions did the failure occur? 5) Had any repairs been carried out before the failure? When were these repairs carried out? 6) Has the same kind of failure occurred before? 6. Measures to remove root cause of failure Even if the failure is repaired, if the root cause of the failure is not repaired, the same failure will occur again. To prevent this, always investigate why the problem occurred. Then, remove the root cause. 3. Check before troubleshooting 1) Check the oil level 2) Check for any external leakage of oil from the piping or hydraulic equipment. 3) Check the travel of the control levers. 4) Check the stroke of the control valve spool. 20-202 PC130-7 (1)