. OPERATION OPERATION If 3 - 53 NORMAL OPERATION After the engine starts, do not st art operating the machine immediately. First, carry out the following operations and checks. NOTICE ine before the warming-up operation is completed. high idle continuously for more than 20 minutes. Do n ot suddenly accelerate the eng ine before the warming-up operation is Do n ot run the engine at low idle or high idle continuously for more than 20 If it i s necessary to run the engine at idle, apply a load from time to time or run the engine at a mid-ra 1. Depress acceleratorpedal ( 1) lightly and run the engine with n load at midrange speed for about 5 minutes. 2.
To warm up the hydraulic o il in cold areas only, do as follow During the warming-up o rotation is smooth, then se peration, check that the engin t the safety lock lever of the wor equipment control lever to the FREE position and move th bucket control lever in and o ut of the TILT position to warm u the hydraulic oil. The relief time at the tilt p seconds. osition should be maximum of 1 With this operation, the oil w ill reach the relief pressure and th will warm up the hydraulic o il more quickly. ming-up operation, check that th are normal. carry out maintenance or repair. light load until engine wat 3.
After carrying out the war gauges and caution lamps If there is any abnormality, Run the engine under a temperature gauge (2) and torque converter oil temperatur ange. st gas color, noise, or vibration. gauge (3) are in the green r 4. Check for abnormal exhau any problem is found, conta ct your Komatsu distributor.