. OPERATION OPERATION CHANGING DIRECTION WARNING Gear speed before changing between FORWARD and REVERSE Gear speed after changing between FORWARD and REVERSE F2 R3 F3 R3 or R4 R2 F3 F4 R3 or R4 R3 F3 or F4 R4 F3 or F4 REMARK If the directional lever is operated slowly or it is stopped between directional range, error code "CALL" may be displayed. This is not a failure: the directional lever must be operated to complete the directional shifting within 2 seconds. 3 - 58 When changing direction between FORWARD and RE VERSE, c heck that the new direction of t machine, so be particular reverse. ravel is safe.
There is a blind s pot behin d the ly careful when changing direction to travel in Do not switch between FO RWARD and REVERSEwhen traveling at high speed. When switching between to reduce the travel spe travel. (Max.speed for cha FORWARD and REVERSE, depress the brake ed sufficiently, then change th e directi nging direction: 12 km/h (7.5 M There is no need to st op the machine even when switching REVERSE. in the desired position. with auto shift, when switching between between FORWARD and Place directional lever (1) On machines equipped with auto shift, when switch FORWARD and REVERS E, the machine starts automatically from 2nd speed.
Manual shift 3rd and 4th s peed, and automatic shift es or at high When traveling in 3rd or 4th on manual shift machin high speed on auto shift mach ines, if it is attempted to sw itch between FORWARD and REVER SE, the alarm buzzer will sound f or 3 seconds (rapid intermitt engine speed are in area ent sound) if the machine I in the chart on the right. between FORWARD and speed and REVERSE in If it is attempted to shift REVERS area II in the chart on the right, the alarm buzzer will s ound, a nd at the same time, the transm ission will shift to the speed range i n the table below and the spee d will be reduced, so the dec eleratio n will be weaker than when the machine is in area I.