. OPERATION TRANSPORTATION METHOD OF LIFTING MACHINE WARNING Never try to lift the machine in any posture other than the posture given in the procedure below or using lifting equipment other than in the procedure below. There is a hazard that the machine may lose its balance. 3 - 84 When lifting the machine at a port or any other place, always use the following procedure t o lift The operator carrying out the li fting operation using a crane mus t be a properly qualified crane operator Never raise the machine with a Always make sure that the wire rope is of ample strength for the weig ht of this machine.
When lifting, keep the machine When lifting the machine, alwa ys stop the engine, apply the parking br ake, and s et the safety lock le ver t o the LOCK p osition. Lock with the safety bar to pr unexpectedly. , an steps achine from moving Never enter the area around or NOTICE he standard specification machine. ding to the attachments and options installed. Thi s method of lifting applies to t he standard specification machine The method of lifting differs accor ding to the attachments and options in For details of the procedure for m achines that are not the standard specification, p lease consul t your Komatsu distributor.
Fo r the weight of the standard specification machine, see "WEIGHT TAB LE (PAGE 3 -85)" NOTICE Use protectors to prevent the wire rope from being cut on sharp corners and t o preven t the wire r ope from cutting into the machine bodywork. ect an ample width to prevent contact with the machine. When using a spreader bar, sel ect an ample width to prevent contact with the m Please consult your Komatsu distributor before carrying out liftin