. MAINTENANCE SERVICE PROCEDURE LUBRICATE REAR AXLE PIVOT PIN (3 places) 1. Using a grease pump, pump in grease through the grease CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING cause burns. Wait for the 1. Lower the the oil level should be between the H and L marks. 4 - 39 EVERY 100 HOURS SERVICE Maintenance f or every 50 hours service should be carried out at the rked by the arrow ing, wipe off any old g rease that was pushed o The parts an d oil are at high te mperature imme diately after the engine is stopped, and may lease the internal pressure, then remove it. temperature t o go down before s tartin g the work.
When removi ng the oil filler cap, turn i t slowly to re lease the intern bucket horizontally t o the grou nd and stop ait for 5 minutes, then check sigh t gauge (G). NOTICE If the oil has bee n added to above H level , stop the en gine and wait for hydraulic oil to c ool down, then drai n the excess oil fr om the drain plu the oil is above H level, it will damag e the hydraulic cir cuit or cause th to spurt out. below the L level, ope n the inspe ction cover ab nd add oil through oil fi ller port (F)