Komatsu — CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC FILTER ELEMENT

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the cover pushed down when material inside the tank, then push down the cover and port (F) to the specified level, HYDRAULIC TANK, ADD OIL extend and retract the 4 - 62 8. Remove mounting bolts (4) of top of the tank, then remove t When the cover is removed, t the cover fly off, so keep removing the bolts. 9. Remove spring (5) and bypas (7). Check that there is no foreig clean it. 10. 11. Install the new element, then and cover (3) to the tank. If the O-ring of the cover is da 12. When installing the cover b tighten the bolts evenly. Add engine oil through oil fill then install cap (F). 13. 14.

Check that the hydraulic oil is see "CHECK OIL LEVEL IN (PAGE 4-39)". Run the engine at low idli 15. steering, bucket, and lift arm c not to operate the cylinder to t 100 mm (3.9 in) before the en NOTICE If the engine is run at high speed imme diately after startup or a cylinder is pushed up to its stroke end, air taken inside th e cylinder may cause damage to the piston pack ing. 16. Next, operate the steering, bu cket, and lift arm cylinders to the , then stop the engine and loosen ir from the hydraulic tank. After (8) again. at the standard level. For details, HYDRAULIC TANK, ADD OIL eed and repeat the procedure in inue this operation until no more operation, tighten plug (8).

Nm 5 kgm , 8.3 ± 1.1 lbft) end of their stroke 3 to 4 times bleed plug (8) to bleed the a bleeding the air, tighten plug 17. Check that the hydraulic oil is see "CHECK OIL LEVEL IN (PAGE 4-39)". Next, increase the engine sp 18. Step 16 to bleed the air. Cont air comes out from plug (8). 19. After completing the air bleed Tightening torque: 11.3 ± 1.5 (1.15 ± 0.1 Tightening torque: 11.3 ± 1.5 20. Check that the hydraulic oil is at the standard level. For details, see "CHECK OIL LEVE L IN HYDRAULI C TANK, ADD OIL (PAGE 4-39)". e of oil from the filter cover mount. 21. Check that there is no leakag e of oil from the filter cover mount.