Komatsu — PRECAUTIONS WHEN OPERATING E.C.S.S. SWITCH

. ATTACHMENTS, OPTIONS HANDLING E.C.S.S.(ELECTRONIC CONTROLLED SUSPENSION SYSTEM) HANDLING E.C.S.S.(ELECTRONIC CONTROLLED SUSPENSION SYSTEM) METHOD OF OPERATING E.C.S.S. The E.C.S.S. switch is on the left side of the main panel. When the E.C.S.S. switch is pressed, it is turned on, the pilot lamp (orange) lights up, and the E.C.S.S. is actuated. If the switch is pressed again, it is turned off, the pilot lamp goes out, and the E.C.S.S. is canceled. PRECAUTIONS WHEN OPERATING E.C.S.S. SWITCH WARNING the E.C.S.S. 6 - 3 Always read this section before usi ng the E.C.S.S.

in order to enable you to use it saf If the machine is traveling or the wor k equipment is raised, the work equipment will move the moment the E.C.S.S. s turned ON. moment operations are started if the E.C.S.S. switch is at the ON position. during operations. The work equipment may move the moment operations are started if the E.C.S.S. switch is at Keep the E.C.S.S. switch turned OFF Never turn the E.C.S.S. switch ON d uring inspection or maintenance. The work equipment will move and this will c dangerous situation. Always stop the machine and lo wer the work equipment to the ground before opera ting the E.C.S.S.

swi When carrying out inspection a nd maintenance, first lower the work equipment t ting the inspection and maintenance operation. o the ground, then tu E.C.S.S. switch OFF before star REMARK If the starting switch is at the OF F position, the E.C.S.S. will not be actuated even if the E.C.S.S. switch is ON position. If the starting swit ch is at the ON position, it is possible to actuate th on, it will switch to the actuated condition. e E.C.S.S.. If the E. switch is turned to the ON positi The E.C.S.S.

will not be actuate d if the transmission is in 1st or if the travel speed is less than 5 km/h (3.1 If the transmission is in 2nd to 4th and the travel speed is more than 5 km/h (3.1 MPH ), the swaying of the c is effectively dampened and by the accumulator pressure in accordance with the c ondition of the load.