. OPERATION EXPLANATION OF COMPONENTS STARTING SWITCH This switch (1) is used to start or stop the engine. OFF position TRANSMISSION CUT-OFF SWITCH WARNING it REMARK For general operations, using the transmission cut-off the rise in the brake oil temperature and torque converter oil temperature. 3 - 18 The key can be inserted a When t key is turned to this positi on, all electric circuits are turned off a the engine stops. In addition, the parking br ON position rrent flows to the charging circuit, lam uit. In this position, electric cu circuit, and accessory circ Keep the starting switch k ey at the ON position while the engine running. START position This is the engine-start po sition.
Keep the key at this position dur ing cranking. Immediately aft er starting the engine, release the key. It will aut omatically return to the ON position. When moving the machine of f on an uphill slope, set the transmission c ut-off switch to the OFF position, depress the ac celerator pedal while keeping the left br ake pedal depressed, then gradually relea se the brake pedal and allow the m achine to mov e. In this way the machine can be prev ented from traveling backwards. Press this push button sw itch (2) to turn ON or OFF. essed, it will light up and come ON; if lamp will go out and the transmissi When the pilot lamp is pr pressed again, the pilot cut-off will be turned OFF.
Set at ON position normally. OFF: Left brake pedal acts as normal brake (like right brake peda ON: Left brake pedal act s as normal brake, but also switch TRAL. transmission to NEU If the switch is turned to O N, the transmission cut-off pilo t lamp w light up. unction reduce