Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. 4. The oil level should be between the H and L marks on dipstick (G). If the oil level is below the L mark, add oil through oil filler (F). The dipstick has level markings on both sides. One side gives the levels for measuring when the engine is stopped (ENGINE STOPPED) and the other side gives the levels for when the engine is idling (ENGINE IDLING).

When measuring the oil level, measure with the engine stopped and use the side of the dipstick marked "ENGINE STOPPED". close the inspection window. REMARK 3 - 40 1. Open the inspection cove r of the right side at the rear of the 2. Take out the dipstick (G) 3. Fully insert dipstick (G) int 5. If the oil is above the H ma rk, drain the excess engine oil from drain plug (P), and check 6. If the oil level is correct, ti When checking the oil level after the engine has been operated, wait for at least 15 minute checking. Checking the oil level with the engine idling may be allowed, if the following precautions a o Check that the engine wa ter temperature gauge shows green range.

o Use the side of the dipsti o Remove the oil filler cap. If the machine is at an checking.