. OPERATION OPERATION OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WARNING repair it. 4. Check for leakage from fuel line. Check that there is no leakage of fuel or damage to the hoses and tubes. If any problem is found, carry out repairs. loose bolts, or leakage of oil from 7. Check for damage to handrail and loose bolts Repair any damage and tighten any loose bolts. 3 - 74 WALK-AROUND CHECK Before starting the engine, walk aro und the machine and look at the underside of chassis for anything unusual l ike loose bolts and nuts, leakage of fu hydraulic system. el, oil and coolant.
Also check the condition of the work equipment and the nd collection of dust at places that reach high temperature. the Also check for loose wiring, play, a nd collection of dust at places that reach high temperature Leakage of oil or fuel, or accumulati on of flammable material around high temperature parts, such a s the engine m uffle r or turbocharger, may cause fire. Check carefully, and if any abnormali ty is found, repair it or contact your Komatsu distributor. ty is found, repair it or contact your Komatsu distr Do not get on or off the machine from the rear. Using this position is dangerous becaus e it is easy to slip and you c anno t be seen from the operator's compartme nt.
Always use the handrail and step at the side wh en getting on or off the machine. If the machine is at an angle, repos Perform the following inspections a nd cleaning every day before starting engine for the day's 1. Check for damage, wear, play i n work equipment, cylinders, linkage, hoses Check for cracks, excessive we found, repair it. ar, play in wotk equipment, cylinders, linkage , and hoses. If any abnormalit y is 2. Remove dirt and debris from ar ound the engine, battery, and radiator Check for dirt accumulated arou grass, etc.) accumulated aroun parts. If any dirt or flammable m nd the engine or radiator.
Also check for flam mable mater ial (dry leave s, twigs, d the battery, engine muffler, turbocharger, or other high temperature engine aterials are found, remove them. 3. Check for coolant and oil leaka ngine and coolant leaks from the cooling sy stem. If any abnormality i s found, 5. Check for leakage of oil from po wer train case, final drive case, hydraulic tan k, hose, join ts Check that there is no oil leaka Check for leakage of oil from th ge. If any abnormality is found, repair the pla ce where the oil is leaking e undercover. Check the ground for traces of oil leakage. 6.
Check the undercarriage (track rollers If any damage, wear, or oil leak age is found, repair the problem and tighten t