. OPERATION OPERATION 3 - 78 CHECK DUST INDI CATOR is located on the air cleaner bracket inside the The dust indicator eaner bracket in side the engine room. It is a safety device to warn when the air cleaner d. element is clogge For the filter eleme nt cleaning method, se e "CHECK, CLE AN AND REPLACE AIR CL EANER ELEMENT (P AGE 4-25)". 1. Check for the dust indicator 2. If the yellow p kPa), either cl immediately. For cleaning t CLEAN AND 4-25)", in this 3. After checking indicator (1) to In environm surface bec etc.), replac to judge the 1. Check for the dust indicator If the yellow p kPa), either cl ean the filter element o r replace it with new one immediately.
he filter element, refer to the section, "CHECK, For cleaning t CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT (PAGE manual. 4-25)", in this 3. After checking , cleaning, and replacin g, press the kno b of dust indicator (1) to return the yellow pisto n to its original position. In environm ents where the rubber d eteriorates quic kly or the omes damaged (in dire ct sunlight, dus ty areas, e before it becomes dirt y and it become s difficult condition. CHECK, DRAIN WATER SEPARATOR The water separat or serves to separate m oisture mixed in the fuel. 1. 2. 3. 4. Open up the engine side cover and inspection cover on the machine's left The water sep located in the l side.
arator is in one piece with fuel pre-filter (1) and ower part. Through trans parent cap (2), a water level and sediments, if seen. When water and sediments have put a container beneath drain hose (3). ) to drain water and sediments. is finished, be sure to screw in plug (4). any, can be accumulated, put a container beneat h drain hose (3). 3. Loosen plug (4 ) to drain water and se 4. When draining is finished, be sure to screw in plug (4 Specified tight eningtorque: 0.2 to 0.4 5 Nm (0.02 to 0. 046 kgm, 0.1 to 0.3 lbft)