Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING valve (1), and drain the excess oil. oil circuit and cause the oil to spurt out. 1. Lower blade to the ground and stop the engine. Wait for 5 the H and L in sight gauge (G). REMARK When inspecting, if the machine is at an angle, move it to a level place to carry out the check. 4) Install cap. 3 - 80 When remo ving the oil filler cap, oil m ay spurt out, so stop the and wait fo r the oil temperature to go down, then push the cap d release the internal pressure before re moving the cap carefully. If oil has be en added to above the H m ark, stop the engine and the hydraul ic oil to cool down.

Then re move drain plug (P), loose NOTICE Check the o il level when the oil is at lo w temperature. If the oil is temperatur e, the oil level will be highe r. Do not add oil if the oil level is above the H line. This may dam before checking oil leve l. Oil level should be be . If the lev el is below the L mark, add oil through oil filler down cap of oil filler (F ) to release the air and remove the internal p cap pushed down, turn it slowly counterclock wise, the n remove ca l the specified quantity o f oil through oil filler (F n installing cap to the ta nk, push it down, then REMARK not installed correctly, it will cause leakage of oil.

If t he cap is not installed correctly, it will cause leakage of o When install ing the cap, press the c ap down, and turn it un til it is securely in con tact with the st opper. The cap is th e lock addition type. About handli ng method of cap with t he lock, see "CAP WIT H LOCK (PAGE 3-48