Komatsu — AFTER RUNNING OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION that no more 3 - 139 AFTER RUNNING OUT O When sta rting the engine again after running out of fu el, fill with fue l, then bleed the air fro m the fuel system before starting t he engine. Always w atch the fuel level an d be careful not to run out of fuel I f the eng ine has stopped beca use of lack of fuel, it is necessary to u se the priming pump to bleed the air completely from the This en gine consists of higher p recision parts than on th e conventional fuel injection pump and n ozzle, so if dirt gets in, it will cause p roblems.

If there is any dirt stuck to the fuel line , use fuel to was h it off completely. Be care ful when opening the ai r bleed plug at the fuel fi lter head and th e air bleeder of the supp ly pump. The system is still under p ressure and fuel may sp 1. Fill th e fuel tank with fuel. 2. Loos 3. Loos en air bleed plug (A), en wing nut (4) holdin 4. Push Chec (A). 5. Wrap sealing tape around air bleed plug (A) befo it. 6. Oper bubb les come out with the fuel from air bleed plu 7. Tight en air bleed plug (B). Tight ening torque: 4.9 to 6.