. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING 3 - 143 It is dangerous to charge a batte ry when mounted on a machine. Make sure that it is dismounted before charging. battery, stop the engine and turn the osition. When checking or handling the starting switch key to the OFF p The battery generates hydrogen gas, so there is a hazard of explosion. Do not bring lighted cigarettes n ear the battery, or do anything that will cause sparks. Battery electrolyte is dilute sulfu ric acid, and it will attack your clothes and skin. If it gets on your clothe s or on your skin, immediately wash it off with a large amount of water.
If it gets in your eyes, wash it out with fresh water and consult a doctor . ys wear safety glasses and rubber When handling batteries, alwa gloves. When removing the battery, first disconnect the cable from the ground (normally the negative (-) termina l). When installing, install the positive (+) terminal first. If a tool touches the positive ter minal and the chassis, there is danger that it will cause a spark, so be e xtremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause a n explosion. When removing or installing the terminals, check which is the positive (+) terminal and which is the neg ative (-) terminal.
REMOVE AND INSTALL BA TTERY remove the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remove the ground cable (normally connected to the nega tive (-) terminal). If any tool touches between t he positive terminal and the chassis , there is a hazard of s parks being generated. When installing the battery, c onnect the ground cable last. secure it with battery hold-down. battery terminal: 9.8 to 14.7 Nm (1 to 1.5 kgm, 7.2 to 10.8 lbft) When replacing the battery, secure it with battery hold-down. Tightening torque:Tightening battery terminal:
9.8 to 14.7 Nm (1 t o 1.5 kgm, 7.2 to 10.8 REMOVAL, INSTALLATION OF B ATTERY CABLE tery, remove the ground cable 1. Open the battery cover (1). 2. Remove tray (2). 3. Before removing the bat (normally connected to the touches between the positiv danger of sparks being g terminal and remove the wi 4. When installing the battery, Insert the hole of the termina Tightening torque: 9.8 to 19 5. Close the cover. 1. Open the battery cover (1). negative (-) terminal). If any tool e terminal and the chassis, there is enerated. Loosen the nut of the res from the battery. connect the ground cable last. 4. When installing the battery, l on the battery and tighten the nut.
.6 Nm (1 to 2 kgm, 7.2 to 14.5 lbft) 5. Close the cover.