Komatsu — GUIDE TO MAINTENANCE

. MAINTENANCE GUIDE TO MAINTENANCE CHECK SERVICE METER: Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. KOMATSU GENUINE OILS: For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature. 4 - 2 GUIDE TO M Do not perform any i nspection and maintenance ope ration that is not fo Stop the machine on flat hard ground when performin g inspections and maintenance KOMATSU GENUINE REPLACEMENT PARTS : Use Komatsu genuin e parts specified in the Parts Bo ok as replacemen ALWAYS USE CLEA N WASHER FLUID:

Use automobile wind ow washer fluid, and be careful not to let any dirt g CLEAN OIL AND GR EASE: Use clean oil and gre ase. Also, keep the containers o f the oil and greas e clean. Keep foreig n materials aw ay from oil and grease. CHECKING FOREIGN MATERIALS IN DRAINED OIL: After oil is changed o r filters are replaced, check the ol d oil and filters for m etal particles and for eign materials. If large quantity of metal pa suitable action. rticles or foreign materials are found, always report to the person in charge, and carry out harge, FUEL STRAINER: If your machine is eq uipped with a fuel strainer, do no t remove it while f WELDING INSTRUCT IONS: Cut off power. Wa it for approx.

one minut e after tu rning off the engin e starting switch key , and then disc onnect the negative (-) te rminal of the battery. When carrying out welding repairs on the f loor fram e, remove all conn ectors from the mac hine controller. There is danger of dama ge to the controller. than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. Do not apply more Connect groundin g cable within 1 m (3.3 instruments, conn ectors, etc., the instruments may malfunction.

If a seal or bearing happens to come between the p art being welded a nd grounding point, change the gro unding point to avoid suc h parts. ea around the work equipment pins or the hydraulic cylinders as the grounding point. Do not use the ar ea around the work equipment pi ns or the hydraulic cylinders as the gro unding DO NOT DROP THIN GS INSIDE MACHINE: When opening ins pection windows or the oil filler p ort of the tank to carry out inspection, be careful not to drop nuts, bolts, or tool If such things are lead to failure. If y s inside the machine.

dropped inside the machine, it m ay cause damage and/or malfunction of the machine, and will ou drop anything inside the mac hine, always remo ve it immediately. r inspection. Do not put unnec essary things in your pockets. C arry only things wh ich are necessary fo