Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEANING OR REPLACING OUTER ELEMENT NOTICE 99.4 6 4 - 26 Before and a fter cleaning the ele ment, do not leave or keep it in direct sunlight. 1. Open t he left engine side cover. 2. Remov e three clips (2), t hen remove cover ( NOTICE Never remov e inner element (5). If it is removed, dust w ill enter and ca engine troub le. 3. Remov 4. Hold th left and it out. 5. Clean evacua 3. Remov e outer element (4 4. Hold th e outer element, r ock it lightly up and down and to right, and rotate t he element to the le ft and right to NOTICE The inner ele ment must not be us ed again even after cle aning.

When re placing the outer element, re place the inner element at the same time. 6. Direct dry compressed a ir (Max. 0.69 MPa (7 kg/cm2, 9 PSI)) fr direct t again f 1) Ch ins 2) Re tim sa om the inside of th e outer element alon g its folds. T he compressed air from the outside alo ng the folds, rom the inside. element is not loose. If it is loo lement which has been cleane eck that the inner ert it securely. place any outer e es or used for 1 ye ar. Replace the inn er element at me time.

en if the outer elem ent has not been cl eaned 6 times , if the yellow piston in the dust indicator goes t o the Pa position immed iately after cleaning (when the en gine is running at high idli ng, replace both the i nner d the outer elemen t.