. MAINTENANCE SERVICE PROCEDURE CLEANING AND INSPECTION OF FINS OF RADIATOR, OIL COOLER AND AFTER COOLER REMARK CLEANING BY ROTATING COOLING FAN IN REVERSE DIRECTION WARNING sure that the parking brake lever is in the LOCK position. position. 4 - 35 Carry out this procedure if t here is any mud or dirt stuck to the radiator or oil Check the hydraulic cooler hoses. If any hose is cracked or hardened by age, replace with a new hose. Also c heck and tighte n all loose hose c When clea ning the cooling fan by turning it in the rev erse direction, make NOTICE When rotat ing the cooling fan i n the reverse direction, be extremely careful of flying du st.
Open up th e right and left engi ne side covers and ch eck that no dust and dirt are acc umulated inside the engine room. When the f an operation confirm ation lamp is lighted a nd the fan is turning in the reve rse direction, the ma chine does not move even if the steering - forward an d reverse - gearshift lever is operated to any of the forward, d steering positions. This function is designed to protect the ft lever is operated to any of the forward, reverse an the radiator. When stop ping the engine whe n the cooling fan is ro tating in the reverse direction, f irst run the engine a t low idling, then stop it.
The dust and dirt stuck to th e radiator and coole r can be blown out by rotatin g the cooling fan i n the reverse directi 1. Turn starting switch (1) to the "OFF" positio n and stop the engine 2. Turn starting switch (1) to the "ON" position 3. Turn ng fan reverse rot ation pilot lamp (3) li