. MAINTENANCE SERVICE PROCEDURE 4 - 45 PROCEDURE FOR BLEEDING AIR IN HYDRAULIC SYSTEM See "STARTI NG ENGINE (PAGE 3-93)". Sinc e the eng ine must be started and t he blade must be operated, see OPE NOTICE If the engine is r un at high spe ed immediatel y after startup or a cylinder is pushed up to it s stroke end , air taken inside the cy linder may cause dam age to the pis 1. Bleeding air from cylin 1) Run t he engine at low idle, and extend and re tract each cylinder 4 to 5 times, tak ing care that a cylinder is oved to the e nd of its stroke. (Stop the c ylinder approx. 100 mm (3.9 in) sh ort of its stroke end) 2) Next, operate eac h cylinde r 3 t o 4 times to th e end of its stroke.
3) Finall y, operate ea ch cylinder 4 to 5 times to the end of its stroke to c ompletely r emove t he air. LUBRICATI 1. Lower the work equip ment to t he g round, then st op the engine 2. Add greas e through a grease f ittin g indicated with an arrow on deceleratio n pedal (1 ), using a grease pu mp 3. After grea sing, wipe o ff any old grease that was p Fuel control (