. MAINTENANCE SERVICE PROCEDURE CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS REPLACE CORROSION RESISTOR CARTRIDGE WARNING 4 - 66 Please ask your Komatsu distributor to check the tightening o f the clamps between the air cleaner - turbocharger - If the engine has been operat ed, all parts will be at a high te mperatu re, so never try to replace th e cartridge immediately after stopping the engine. Always wait for the engine an Container to catch drain ed coolant for fuel filter element. osion resistor (1) as far as the CLOSE Prepare a filter wrench 1. Turn valve (2) of corr stopper. 2. Set a container to catc 3. Using a filter wrench, t 4.
Clean the filter holder, the new cartridge with 5. When installing, tighte seal surface of the filte If the filter cartridge is damaged and this will If the filter cartridge is t packing, so always tig 6. Turn valve (2) of the c 7. After replacing the cart coolant leakage from leakage, check if the c h the coolant under the cartridge. urn cartridge (3) to the left to remove it. 4. Clean the filter holder, coat the packing surface an d threa d of oil, then install it to the filter holder. n until the packing surface c ontacts the r holder, then tighten it up 2/ tightened too far, the pack 3 of a turn. ing will be lead to leakage of coolant.
oo loose, coolant will also le ak from the hten to the correct amount. n. eck for any 6. Turn valve (2) of the c 7. After replacing the cart artridge to the OPEN positio ridge, start the engine and ch the filter seal surface. If th ere is any . any artridge is tightened properly