. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 7. Operate the blade control lever fully in the direction to lower the blade. NOTICE 4 - 71 3. Raise th e work equipme nt (blade) to the maximum height. NOTICE ollowing procedure for lowering the blade to the ground within 15 seconds after stopping the engine. Carry out the f ollowing procedu re for lowerin g the blade to th e ground with in 15 seconds af ter stopping the engine. When the engi ne is stopped, the pressure ins ide the accumula tor gradually goes down, so thi s inspection can be carried ou t only immediately a fter the engine is stopped. 4.
While ho lding the work e quipment at the highest po sition, t the engin e starting switc h key to OF F position (A). 5. Turn the engine starting switch key t o ON position 6. Turn the work equipmen t lock lever to FREE positi REMARK Check that t he area around t he machine is safe, then o perate blade contro l lever to the LO WER positi 8. Check th at the work equipment goes down to the gro und its own w 9. This com If the nitrogen gas charge press ure in the acc umulator is low and operation s are continued, it will become impossibl e to r elease the remaining pressure inside th e hydraulic c ircuit if a failure occurs o n th